13/BRAKE SYSTEM
77
14.8
Changing rear brake linings
Warning
Danger of accident
Brake system failure.
–
Maintenance work and repairs must be carried out professionally.
Warning
Skin irritation
Brake fluid can cause skin irritation on contact.
–
Avoid contact with skin and eyes, and keep out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
If brake fluid comes into contact with the eyes, flush the eyes thoroughly with water and consult a physician immediately.
Warning
Danger of accidents
Reduced braking effect caused by old brake fluid.
–
Change the brake fluid of the front and rear brake according to the service schedule.
Warning
Danger of accidents
Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
Warning
Danger of accidents
Reduced braking efficiency due to use of non-approved brake linings.
–
Brake linings available from accessory suppliers are often not tested and approved for use on KTM vehicles. The construc-
tion and friction factor of the brake linings and therefore the brake power can differ considerably from the original KTM
brake linings. If brake linings are used that differ from the originals, there is no guarantee that they comply with the origi-
nal license. The vehicle no longer corresponds to the condition at delivery, and the warranty is no longer valid.
Warning
Environmental hazard
Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Never use DOT 5 brake fluid! It is silicone-based and purple in color. Oil seals and brake lines are not designed for DOT 5
brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container.
100259-10
–
Stand the vehicle upright.
–
Remove the screw cap
with the membrane
.
–
Press the brake caliper onto the brake disc by hand in order to push back the brake
pistons. Make sure that no brake fluid escapes from the brake fluid reservoir. If it
does, clean it up.
Info
Make sure when pushing back the brake piston that you do not press the
brake caliper against the spokes.
100288-10
–
Remove the safety clip
, knock the pin
out to the left, and remove the brake
linings.
–
Clean brake caliper and brake caliper support.
Summary of Contents for 690 SMC 2008
Page 1: ...REPAIR MANUAL 2008 690 SMC EU 690 SMC AUS UK 690 SMC USA Article no 3206042en...
Page 2: ......
Page 185: ...183...
