07/FUEL TANK, SEAT, TRIM
54
10.1
Opening filler cap
100227-10
–
Lift the cover of the filler cap
and insert the ignition key.
–
Turn the ignition key 90° counterclockwise and remove the filler cap.
Info
The filler cap has a tank air vent system.
10.2
Closing filler cap
100228-01
–
Put the filler cap back on and turn the ignition key 90° clockwise.
–
Remove the ignition key and fold down the cover.
10.3
Removing the seat
100230-10
–
Pull on strap
and raise the rear of the seat at the same time.
–
Pull back the seat and lift it off.
10.4
Mounting the seat
100276-10
–
Hook slot
of the seat onto screw
, press the rear downward and at the same
time push it forward.
–
Push locking pin
into lock housing
and push the back of the seat down until
the locking pin locks in place with an audible click.
–
Finally, check that the seat is correctly mounted.
10.5
Taking off the side cover
–
Remove the seat. (
300198-10
–
Remove screws
.
–
Pull off the side cover in area
and take off from above.
–
Repeat the operation on the opposite side.
Summary of Contents for 690 SMC 2008
Page 1: ...REPAIR MANUAL 2008 690 SMC EU 690 SMC AUS UK 690 SMC USA Article no 3206042en...
Page 2: ......
Page 185: ...183...
