KTM 125 SX 2010, Owner'S Manual

Page: 638 / 899

– Replace the rear lid carefully.
– Be sure that the front and rear lid are correctly lined up.
– Screw the nuts on the treaded rod and tighten them with the
adjustable pin spanner T103.
– Hold the threaded rod while screwing the nuts, to avoid the rods
from piercing the front sticker of the oil reservoir.
– Now place back the oil reservoir in the reversed order.
Filling damper oil
– Remove the filling plug of the oil reservoir.
– Fill the oil reservoir until the level indicator reaches max. level.
Place back the filling plug using a torque wrench. The filling plug
has to be fastened with a torque of 10 Nm.
! CAUTION !
T
HE VACUUM
-
FILLING UNIT SHOULD ALWAYS BE IN THE UPRIGHT POSITION
,
TO
AVOID OIL SPREADING TROUGH THE ENTIRE SYSTEM
! T
HIS WILL CAUSE SERIOUS
DAMAGE TO THE VACUUM FILLING DEVICE
. O
NLY USE OIL APPROVED BY
WP
S
USPENSION
!
Vacuum air bleeding of damper oil
– Before the unit can be used, the oil in the oil reservoir should be put
under vacuum in order to get rid of the air inside of the oil.
– The control levers should be in the following positions (after new oil
filling):
External tank Closed
Damper Vacuum
Oil reservoir Vacuum
– Now switch the power on and let the filling device run for about 2
minutes, switch off the power. The vacuum-filling device is now
ready for use.
4-26