KTM 125 SX 2010, Owner'S Manual

Page: 305 / 899

8
7
bk
7-13
Measuring conditions:
– cold engine
– seat and tank removed
– all connectors and the ground connection in a non-corroded condition and connectors tightly connected
– light switch turned off
– kick the kick starter forcefully at least 5 times for each measurement
Static generator values (except 250 EXC USA)
Check the generator output
6
(also see circuit diagram on opposite
page) for voltage between the following cable colors:
– between yellow and brown (ground), connector
7
disconnected
Multimeter display (250): 19 volts ±2 volts
(300): 15 volts ±1 volts
– between white and brown (ground), connector
8
disconnected
Multimeter display (250): 24 volts ±2 volts
(300): 19 volts ±1 volts
– Repeat both measurements with connectors
7
and
8
connected.
The measured values should be the same.
NOTE: The black measuring lead of the peak voltage adapter must be
applied to the ground.
Check regulator rectifier output voltage
9
(except 300 XC-W, also see
circuit diagram on opposite page) cable colors yellow/red, regulator rec-
tifier
bk
connected, capacitor
bl
disconnected:
– between yellow/red and brown (ground)
Multimeter display: 14 volts ± 1 volt
NOTE:
– The black measuring lead of the peak voltage adapter must be
applied to the ground.
– 300 MXC USA corresponds to 300 EXC Europe but with less acces-
sories (blinkers, horn, no capacitor installed). Features no rectifi-
cation, only an over-voltage regulation.
STATIC GENERATOR VALUES
250/300 MXC/EXC (KOKUSAN 2K-3) 2005
250/300 EXC/EXC SIX DAYS, 300 XC-W (KOKUSAN 2K-3) 2006