Krone BiG Pack 870 HDP XC, Original Operating Instructions

Page: 66 / 410

7 Initial operation
7.4 Adjusting universal shaft [BYPY]
66
BiG Pack 870 HDP XC
Original Operating Instructions 150000760_00_en
To do this:
ü The drawbar height has been adjusted, refer to page 64 .
„
Use an eligible auxiliary tool in order to support the intermediate bearing during the whole
adjustment process.
„ Remove the screws (2) of the intermediate bearing.
„
Move intermediate bearing (1) in the hole pattern.
„ Mount the screws (2).
Tightening torque, refer to page 238 .
7.4 Adjusting universal shaft [BYPY]
It must be possible to push together the both universal shaft halves in the narrowest position
(cornering with maximum steering angle and simultaneously driving a slope up or down) without
any contact of the both section tube ends. In this process, the displacement path (overlap) must
be at least 220 mm, both in straight-ahead driving and when cornering.
BP000-087
ü
The machine is shut down and safeguarded, refer to page 25 .
„ Pull apart the universal shaft halves.
Inner universal shaft half
„ Unscrew the screws (3) and remove the inner guard tube (4).
„
Widen the inner raceway (2) and remove it.
Outer universal shaft half
„
Screw out the screws of the protective collar (6) and the screws of outer guard tube (5).
„
Remove the outer guard tube (5).
„ Remove the protective collar (6).
„
In order to protect the retaining spring (10) against loss, unhook the retaining spring (10)
and leave it in one of the both boreholes of the slide ring (9).
„
Widen the outer raceway (8) and the slide ring (9) and remove them.