153
⑸
Check the data and press SAVE. The data is recorded and the
number of registrations possible declines by 1. Because the same
data can not be recorded a second time. REC is not displayed after
recording.
SAVE
REC/Dist.
S m
ZA 45° 18′ 23″ 3
HAR 87° 23′ 09″
Pt.
：
2001
OBS. OFFS AUTO
⑹
Press OBS. to measure the distance again in Record Mode.
OBS.
REC/Dist.
Dist PC = -30
PPM = 0
Fine “S”
STOP
⑺
Press ESC to restore the “Record Mode Screen.”
ESC
1. Stn data A:\JOB01
2. back sight data
3. angle data
4. dist data
5. Coord data
6. dist+ coord data
·
Perform distance measurement to record automatically by pressing a single key: AUTO.
When this key is used, it is unnecessary to perform distance measurement in MEAS Mode. Press AUTO on the
“Record Mode Screen” to perform distance measurement and automatically record the results. When this is done,
the point number automatically increases from that displayed when the KTS entered Record Mode and the code
that was displayed is used unchanged. After measurement has been completed, the results are display for 2 seconds
and the screen displayed before AUTO was pressed is restored.
Offset measurement in Record Mode: OFFSET
It is possible to advance through “Offset/Dist” and “Offset/Angle” by pressing OFFSET. See “12. Offset
Measurement” for the procedure.
21.5 Recording Coordinates Data
·
It is possible to record codes and the measured coordinates data only in a JOB after entering Record Mode.
·
Once the data has been recorded. REC can not be displayed in order to prevent double recording.
·
It is convenient to use AUTO to perform automatic operation from angle measurement to recording.
·
The items which can be recorded are the vertical angle, horizontal angle, point number, code, and target height.
Summary of Contents for KTS440 L Series
Page 9: ...9 3 NOMENCLATURE ...
Page 10: ...10 ...
