152
the point number automatically increases from that displayed when the KTS entered Record Mode and the code
that was displayed is used unchanged. After measurement has been completed, the results are display for 2 seconds
and the screen displayed before AUTO was pressed is restored.
21.4 Recording Distance Measurement Data
·
It is possible to record the most recently measured distance measurement data in a JOB. And it is possible to
perform and record distance measurements, offset measurements, etc. after entering Record Mode.
·
Once the data has been recorded, REC can not be displayed in order to prevent double recording.
·
It is convenient to use AUTO to perform automatic operation from distance measurement to recording.
·
The items recorded are slope distance, vertical angle, horizontal angle, point number, codes, and target height.
PROCEDURE
Operating Procedure
Operation
Display
⑴
Perform coordinate measurement in the “MEAS Mode
Screen.”
Meas. PC -30
PPM 0
S 1234.789 m
ZA 89°59′54″
HAR 90°01′00″
P2
SD SHV HSET EDM
⑵
Press REC on the second page of MEAS Mode.
REC.
1. Stn data A:\JOB01
2. back sight data
3. angle data
4. dist data
5. Coord data
6. dist+ coord data
⑷
select “.
4. dist data
” and press ENT (or press
numeric key 4), the measurement results are
displayed on lines 2 to 4. (Lines indicated by “*”)
“4. Dist
data”
+
ENT
REC/Dist.
*S 10.364 m
*ZA 76° 34′ 17″ 3
*HAR 64° 22′ 10″
Pt.
：
2000
REC OBS OFFS AUTO
⑷
Press REC to record the measurement data indicated by the
“*”.
Enter following items: point number, code, target height
R.HT.
·
KTS automatically increments the last input number by 1 and
display it. This point number can be used to record data in the
memory or can be changed.
·
Codes registered in advance can be read in by pressing CODE
REC
S 10.364 m
ZA 76°34′17″
HAR 64°22′10″
Pt. : 2000
code kolida
SAVE R.HT CODE
Summary of Contents for KTS440 L Series
Page 9: ...9 3 NOMENCLATURE ...
Page 10: ...10 ...
