Kohler COMMAND PRO CS10, Service Manual

Page: 95 / 154

9.11
Section 9
Disassembly
9
Figure 9-43. Disassembling Valve Assemblies.
4. Remove and replace the intake valve stem seal
whenever the cylinder head is serviced or
diassembled. See Figure 9-44.
Figure 9-44. Removing Intake Valve Stem Seal.
5. If the cylinder head is being replaced, the
carburetor mounting studs can be removed by
using the air cleaner base nuts locked together.
See Figure 9-45.
Figure 9-45. Removing Carburetor Mounting
Studs.
Remove Flywheel
NOTE: Whenever possible, an impact wrench should
be used to loosen the flywheel retaining nut. A
flywheel strap wrench, or an approved holding
tool (see ‘‘Special Tools’’ page 2.2 and 2.3)
may also be used to hold the flywheel when
loosening or tightening the flywheel retaining
nut.
NOTE: Always use a puller to remove the flywheel
from the crankshaft. Do not strike the flywheel
or crankshaft as these parts could become
cracked or damaged.
1. Remove the flywheel retaining nut, washer, and
drive cup. See Figures 9-46 and 9-47.
Figure 9-46. Removing Flywheel Nut using an
Impact Wrench.