Kohler COMMAND PRO CS10, Service Manual

Page: 137 / 154

11.15
Section 11
Reassembly
11
Figure 11-59. Carefully Align Keyway to Key.
4. Use a flywheel holding tool and torque wrench to
tighten flywheel nut. Torque the hex. nut to:
CS4, CS6, CS8.5 (spec. 95xxxx):
65 N·m (48 ft. lb.)
CS8.5 (spec. 92xxxx), CS10, CS12:
120 N·m (88 ft. lb.)
Figure 11-57. Clean and Dry Taper of Crankshaft.
NOTE: Make sure the flywheel key is installed
properly in the keyway. The flywheel can
become cracked or damaged if the key is not
installed properly.
1. Install the woodruff key into the keyway of the
crankshaft. Make sure that the key is properly
seated and parallel with taper of shaft.
Figure 11-58. Clean and Dry Flywheel Hub.
2. Install the flywheel onto the crankshaft being
careful not to shift the woodruff key.
3. Install the drive cup (with grass screen if so
equipped) engaging it with the flywheel. Hold in
position and install the large flat washer and hex.
nut. Finger tighten to keep cup engaged.
Figure 11-60. Tightening Flywheel Nut.
Install Ignition Module
1. Turn the flywheel so the magnet is away from the
location where the ignition module will be
installed.
2. Install the ignition module loosely to the bosses
with the two hex. flange screws. Move the module
as far away from the flywheel as possible, then
tighten the screws just enough to hold it in
position.