Kohler COMMAND PRO CS10, Service Manual

Page: 150 / 154

11.28
Section 11
Reassembly
Figure 11-111. Tightening Fuel Tank Mounting
Screws.
CS8.5 (spec. 95xxxx)
1. Install the fuel tank support to top of crankcase.
Align the four mounting holes with the crankcase
locations. Install and finger tighten the four M8
hex. flange screws, with flat washers under each
head. Install the single M6 hex. flange screw in
the hole, as shown, and thread it into the throttle
control bracket. Torque the four M8 screws to
27-31 N·m (238-274 in. lb.) and the single M6
screw to 8-12 N·m (71-106 in. lb.). See Figure
11-112.
Figure 11-109. CS8.5-12. Adjusting Governor.
Install Fuel Tank
CS4, CS6, CS8.5 (spec. 92xxxx), CS10, CS12
1. If the fuel shut-off valve was removed or serviced
separately, install and secure with the flange nut
so the outlet faces directly to the left. The O-Ring
on the fitting must be in good condition. Replace if
deteriorated in any way.
Figure 11-108. CS4, CS6. Adjusting Governor. Figure 11-110. CS4, CS6, CS8.5 (spec. 92xxxx),
CS10, CS12. Shut-Off Valve Orientation.
2. Install the fuel tank assembly onto the mounting
brackets. Secure with the four M6 hex. flange
screws and a flat washer [CS8.5 (spec. 92xxxx),
CS10, CS12 only] under each screw head. Torque
the screws to 8-12 N·m (71-106 in. lb.).
3. Connect the fuel line to the shut-off valve and
secure with the clamp.