Kohler COMMAND PRO CS10, Service Manual

Page: 91 / 154

9.7
Section 9
Disassembly
9
Remove Right Fuel Tank Bracket (if so
equipped), Switch Bracket, Electric Starter,
and Housing/Cover Panel Assembly
1. Disconnect the wiring harness bullet connectors
for the oil sentry and ignition module. Remove the
mounting screw securing the ground lead. See
Figures 9-24 and 9-25. Disconnect the rectifier-
regulator lead connections if used.
Figure 9-26. CS4, CS6 Right Tank Bracket
Mounting Details.
Figure 9-27. CS8.5 (spec. 92xxxx), CS10, and CS12
Right Tank Mounting Bracket Details.
Electric Start Engines Only
3. On CS8.5 (spec. 95xxxx) remove the two screws
securing the control panel and mounting bracket
for the electrical components. See Figure 9-28.
Figure 9-24. CS8.5 (spec. 92xxxx), CS10, and CS12
Ground Lead Location.
Figure 9-25. CS8.5 (spec. 95xxxx) Ground Lead
Location.
2. Remove the two front fuel tank bracket (not used
on CS8.5 [spec. 95xxxx]) mounting screws,
attaching the throttle lever mechanism, switch and
oil sentry light bracket. On electric start engines
the electrical control panel housing will also be
included. Note the washer used on PTO side
screw only. See Figure 9-31.
Figure 9-28. Removing Control Panel Screws on
CS8.5 (spec.95xxxx).