Kohler COMMAND PRO CS10, Service Manual

Page: 149 / 154

11.27
Section 11
Reassembly
11
Install Air Cleaner Base and Element
1. Install the air cleaner base gasket onto the
mounting studs. Attach the breather hose onto the
air cleaner base connection port. Then install the
air cleaner base onto the studs. Connect the
opposite end of the breather hose to the valve
cover. Secure the base with the two hex. flange
nuts on the mounting studs and the one or two
hex. flange screw(s) into the support bracket(s),
depending on the model involved. See Figures
11-104, 11-105, and 11-106. On CS8.5 (spec.
95xxxx) only, install or make sure the rubber seal
for the air cleaner is clean, installed, and in good
condition. See Figure 11-106.
Torque hex. flange nuts to:
CS4, CS6: 5-8 N·m (44-71 in. lb.)
CS8.5-12: 10-12 N·m (88-106 in. lb.)
Torque hex. flange screw(s) to:
5-8 N·m (44-71 in. lb.)
Seal
Seal
Figure 11-104. CS4, CS6. Installing Air Cleaner
Base.
Figure 11-105. CS8.5-12. Installing Air Cleaner
Base.
Figure 11-106. CS8.5 (spec. 95xxxx). Air Cleaner
Base and Rubber Seal.
2. Make sure the seal is on the air cleaner base
stud. See Figures 11-104, 11-105, and 11-106.
Install the filter element with precleaner and
secure with the wing nut. Do not install the outer
air cleaner cover and knob at this time.
Figure 11-107. Installing Air Filter Element,
Precleaner, and Wing Nut.
Adjust/Set Governor
1. Adjust and set the governor as follows (See
Figures 108 and 109):
a. Rotate the governor lever clockwise until it
stops.
b. Turn the governor shaft clockwise until it
stops.
c. Torque the clamp bolt to:
CS4, CS6: 8 N·m (71 in. lb.)
CS8.5-12: 10 N·m (88.5 in. lb.)