Kodak I5X50 SERIES, Setup Manual

Page: 49 / 100

A-61848 / TWAIN October 2016
45
• The Maximum Length will always range from 2.5 to 180 inches but
the true maximum length of the scan will depend on the bit depth
(color/grayscale/black and white and the resolution used for the
scan). Black and white 200 dpi will be 180 inches, but color 600 dpi
will be much less. If the scanner’s processing capacity is exceeded
before the user-selected
Maximum Length is reached, then a
document jam will be displayed on the Operator Control Panel of the
scanner and the image will not be sent to the host application.
• If scanning a stack of mixed documents, where some of the
documents are very long, the best option may be to select when to
enable
Longest scanning by using either the Allow Maximum Length
override or the Maximum Length Detection batch override option
from the scanner’s Operator Control Panel.
• When Controlled Dual Stacking is enabled, the default setting will be
limited to the maximum length of 10 inches/254 mm. See Chapter 5,
“Length Protection Enabled” in the User’s Guide for more
information.
Intelligent Document Protection — allows you to select how
aggressively the scanner detects documents that enter the scanner
incorrectly. This can occur when documents are not prepared properly
for scanning (e.g., stapled or paper clipped documents)
.
• (none)
• Minimum: select this option if the scanner is stopping too frequently
on documents that you do not want it to detect.
NOTE: Documents may become more damaged before detection
occurs.
• Normal: this is the recommended option as it provides a balance
between minimizing document damage and stopping the scanner
unnecessarily.
• Maximum : select this option to get the least amount of document
damage.
NOTE: This may cause the scanner to stop unnecessarily.
Action when paper jam occurs — allows you to select what happens
when the scanner detects a paper jam.
• Stop Scanning : scanning will stop and control will return to the
scanning application (i.e., ends the job). Verify that the paper path
has been cleared and restart the scan session from the scanning
application.
• Pause Scanning : scanning will stop but the scanning application will
be waiting for additional images (i.e., stops the feeder). Clear the
paper path, then scanning may be resumed by pressing the
Start/
Resume button on the scanner. Scanning may be stopped by
pressing the Stop/Pause button on the scanner or via the scanning
application.
Diagnostics — displays the Diagnostics tab.