Kodak I5X50 SERIES, Setup Manual

Page: 45 / 100

A-61848 / TWAIN October 2016
41
• 100 Sheets — this selection is recommended when you are
scanning between 25 and 100 sheets from the input elevator.
• 250 Sheets — this selection is recommended when you are
scanning between 100 and 250 sheets from the input elevator.
• 500 Sheets — this selection is recommended when you are
scanning between 250 and 500 sheets from the input elevator.
• 750 Sheets — this selection is recommended when you are
scanning between 500 and 750 sheets from the input elevator.
• Flatbed — the scanner will scan from the flatbed.
NOTE: The Automatic and Flatbed options are only available if you
had the flatbed accessory attached when the scanning
application connected to the scanner.
Power
• Power Saver — allows you to set the amount of time, in minutes, the
scanner has to be inactive before going into power saver mode.
• Power Off — check this option to set the amount of time, in minutes,
the scanner has to be in power saver mode before it automatically
turns off.
NOTE: The Power settings are shared with all Setting Shortcuts. Any
changes will affect other shortcuts unless you turn on the Only
save to this Setting Shortcut option.
Document Feeder
• Timeout : allows you to select the amount of time, in seconds, the
scanner will wait once the last document enters the feeder before the
timeout action occurs. This option can be turned
off .
• Action when timeout occurs : indicates the action that will be taken
when the document feeder timeout has been reached.
- Stop Scanning : scanning will stop and control will return to the
scanning application (i.e., ends the job).
- Pause Scanning : scanning will stop but the scanning application
will be waiting for additional images (i.e., stops the feeder).
Scanning may be resumed by pressing the
Start/Resume button
on the scanner. Scanning may be stopped by pressing the Stop/
Pause button on the scanner or via the scanning application.
- Pause Scanning - wait for paper: scanning will stop but the
scanning application will be waiting for additional images (i.e.,
stops the feeder). Scanning will be resumed by placing
documents into the input elevator. Scanning may be stopped by
pressing the
Stop/Pause button on the scanner or via the
scanning application.