26
Messages
Sensocheck can generate a message
for failure or maintenance request.
It can be seen in the Message list of
the Diagnostics menu.
Setting the Sensor Data Parameters
Sensor data: Sensor monitoring details
Note:
Function check (HOLD) mode active
Menu
Sensor SE 740 (Administrator)
20.1 °C
Pressure correction
Sensor data
Cal preset values
100.4 %Air
Salinity correction
Messages
Input filter
Sensor data (Administrator)
20.1 °C
Abort
100.4 %Air
Display
Display
Parameter selection
Sensoface
OK
Sensocheck (Administrator)
20.1 °C
Abort
100.4 %Air
Off
Failure
Maint. request
Message
Sensor monitoring details (Administrator)
20.1 °C
Zero
Sensocheck
100.4 %Air
Sensor wear
Temperature
Slope
Return
(Auto)
(Auto)
(Auto)
(Auto)
(Auto)
Monitoring
Auto
Sensoface
provides information on
the sensor condition. Great devia-
tions are signaled. Sensoface can be
switched off.
Sensor Monitoring Details
The following parameters are moni-
tored: slope, zero, temperature, sensor
wear, CIP/SIP counter, O
2
measurement
with CIP/SIP, autoclaving counter and
sensor operating time. For “Auto”, the
tolerance limits are displayed in gray.
For “Individual”, the settings can be
specified by the user.
Sensor Data
(see following page)
Sensor data are preset depending on
the sensor type.
Gray display lines cannot be edited.
Sensor monitoring details
Measure in
Gases
Liquids
Return
Block
N
ot
e:
T
he displa
y ma
y v
ar
y depending on the devic
e v
ersion.
