10
2.1.5 Malfunctions
If safety-relevant malfunctions occur with the grinding units, or if the operating behavior indicates
that such malfunctions may have occurred, the grinding units must be stopped immediately until
the malfunction has been found and eliminated.
Malfunctions may only be eliminated by authorized qualified personnel.
2.2 Intended use
The HV 203 and HV 262 grinding units are exclusively intended for grinding linear and sickle-
shaped flat machine knives (e.g. cutter knives). They are suitable for mounting on the KNECHT
grinding machines of the S 200 model series.
All knives must be clamped onto the corresponding holding fixtures for grinding. First, check
whether the holding fixture matches the knife to be ground. The knife can only be ground if this
is the case.
Any other use is considered as not intended. KNECHT Maschinenbau GmbH is not liable for any
damage resulting from this. The user alone bears this risk.
Intended use also includes observing all instructions in the operating manual.
ATTENTION
The grinding unit is being used improperly,
if, e.g.
• it is installed onto grinding machines other
than the KNECHT S 200 series,
• the knife has been clamped incorrectly,
• the knife is ground without being clamped,
• protective equipment is not properly
attached.
2.3 Warranty and liability
Warranty and liability claims in case of personal injury or property damage are excluded if such
damage is attributable to one or more of the following causes:
• improper use of the grinding units,
• improper transport, commissioning, operation, and maintenance of the grinding units,
• operating the grinding units with defective safety devices, or improperly installed safety and
protective devices,
2. Safety
