1
37
Position the carriage approximately in the center
of the right grinding surface of the cup grinding
wheel and lightly clamp it using a hexagon screw-
driver, width across flats 6 mm (7-29/1). It must
still be possible to move it by hand.
Swivel the carriage forward so that the mounting
head (7-30/1) is pointing vertically downwards.
Move the grinding unit forward (see chapter
7.1.3) until the mounting head (7-30/1) is
positioned above the grinding wheel.
Align the carriage in the center of the right
grinding surface.
Swivel the carriage backward until the mounting
head (7-31/1) points upwards.
Move the grinding unit backward.
Figure 7-29
Clamp carriage lightly
Figure 7-30
Positioning the mounting head to
the grinding wheel
Figure 7-31
Swiveling the carriage backward
7. Operating the HV 203
2
1
1
