13
After completing maintenance work and rectifying any faults, install all safety devices
and verify that they are fully functional.
2.4.10 Structural modifications to the grinding units
Modifications, retrofits or rebuilds of the grinding units are not allowed without the permission of
the manufacturer. This also applies for installation and configuration of the safety devices.
Any conversion work requires the written permission from KNECHT Maschinenbau GmbH.
Immediately replace any machine parts that are not in a serviceable state.
Use only original replacement and wear parts. When using external parts, it cannot be guaranteed
that they are constructed and manufactured to be suitable and safe.
2.4.11 Cleaning the grinding units
Properly handle any cleaning agents and materials used and dispose of them in an
environmentally-friendly manner.
Dispose of the wear parts and replacement parts in a safe and environmentally-friendly manner.
2.4.12 Lubricants / oils and greases
When using oils and greases, follow the safety regulations applicable to the product. Comply with
the special regulations for the foodstuffs sector.
2.4.13 Relocation of the grinding machine with grinding units
Disconnect the grinding machine from any external current supply, even if adjusting its position
slightly. Before restarting the grinding machine, properly connect it to the power supply.
When loading or unloading, only use suspension devices and load suspension devices with
sufficient load-bearing capacity. Designate a qualified instructor for the lifting operation.
Ensure that only persons authorized to carry out this work are located where the machine is
unloaded and installed.
Use only a suitable transport vehicle with sufficient carrying capacity. Secure loads safely. See also
the operating instructions for the S 200 Universal Wet-Sharpening Machine (chapter “4. Trans-
port”). When recommissioning, do so only in accordance with the operating instructions.
2. Safety
