Kiramek 1370S, Owner'S Manual, Page: 44 / 48

VISION 1370S INSTALLATION GUIDE
13 13
MOUNTING SYSTEM COMPONENTS
The Antenna Unit is a vital component of the 1370S and must be mounted
in an appropriate location to obtain the best RF reception and transmis­
sion. Consider mounting at an elevated point on the driver’s side window
pillar, but keep in mind that the wire harness is only 150cm (5ft.) long.
Mount with the included double­sided tape and try to hide the wire har­
ness from view.
Antenna Unit
NOTE: Even though the antenna unit included with the 1370 has a
“CALL” button on it, the CALL function is not supported. Pressing the
CALL button does nothing on 1370 systems. (If you are reviewing this
manual prior to purchase, note that the antenna CALL button is sup­
ported on the VISION 1770 and SCIBORG 825 & 721 systems.)
CAL
L
The shock sensor is not waterproof so only mount it inside the car . Use the
included 2­sided tape and mount the sensor to the steering column plastic
or any plastic surface near the steering column. It’s not necessary to hide
the shock sensor from view, and it would even make changing the sensitiv­
ity easier by mounting it in open view. NEVER use screws or wire ties to
mount the sensor! Always mount to plastic! Mounting to metal can cause
false triggering. Try to test the sensor before permanently attaching it with
the 2­sided tape.
Shock Sensor
IMPORTANT!
Always mount the 318­052 shock sensor more than
30cm (1ft.) away from the antenna unit and the control module of the
optional 318­04 Ultrasonic Sensor. Keep the shock sensor and shock sen­
sor wires more than 30cm away from the antenna unit and antenna unit
wires. Failure to do so may cause the shock sensor to randomly false trig­
ger the siren. Also, try to keep the antenna out of direct sunlight!