Kiramek 1370S, Owner'S Manual, Page: 37 / 48

6
VISION 1370S INSTALLATION GUIDE
THE 14-PIN MAIN HARNESS
This wire supplies (–) 0v ground (500mA max.) while the 1370S is armed.
This output is intended to be connected to the Yellow wire (“86”) of the op­
tional 896H­1B starter kill relay harness, as shown in Fig­1 below.
H1
H1-1 YEL wire: (–) GWA / Starter Kill Output
TIP:
You may also attach low­current devices, such as scanning LEDs, to
the YELLOW wire. These devices will turn on when the 1370 is armed. A
relay will be needed if your combined devices (including starter kill relay)
exceed 500mA.
This wire supplies a (–) 0v Ground (1.5A max.) output to operate the in­
cluded siren during a security breach. See Fig­2 below.
H1-2 ORG wire: (–) Siren Output
MAIN
HARNESS
H1
FIG­2: Connecting to the Siren
ORG BLK
SIREN
RED
BLU*
*CUT BLU WIRE FOR 6-TONE SOUND.
BATTERY
NOTE:
You do not need to touch the blue loop wire on the siren un­
less you want to have 6­tone sound. (Leaving the blue wire uncut puts the
siren in single tone sound mode.)
896H-1B
RELAY
IGNITION
SWITCH
MAIN
HARNESS
85
86
87
30
87a
STARTER
OFF
ACC
ON
ST
PUR
cut
BLU
YEL YEL
H1
FIG­1: Starter Kill Wiring