Kiramek 1370S, Owner'S Manual, Page: 11 / 48

Úåå+)2!-%+å).#
System Operation
%RRORå#HIRP
When you arm the 1370S, the system ignores shock sensor “Warning” trig-
gers while Status LED is lit solid. If there is any other trigger while the
LED is lit solid (IG, Door, Shock Full Trigger), the siren will chirp 2 times
(“error chirp”) and the hazard lights will flash twice and that trigger sec -
tor will be bypassed. (No siren chirps will sound in Silent Mode.) If the
bypassed sector is later secured (i.e., the opened door was later closed), the
system will silently re-enable that sector 5 seconds later.
å./4% Your 2-way pager will update its icons during an error chirp
condition to show the bypassed sector. However, the pager will not update
if that sector is later re-enabled—press the button to update status.
./å#/.&)2-!4)/.å#()20å-%4(/$åå
This method of arming is identical to the
“Normal” method except there is no si-
ren chirp emitted after you arm. Ensure
that all doors are closed and then press But-
ton-III on the Pager remote. After you press Button-
III, the doors will lock and hazard lights will flash once (if so installed).
The Pager Remote will beep once and update (see Fig-1 ), and Status LED
will light solid for 5 seconds. (The siren can’t be triggered while the LED
is lit solid — See “Error Chirp” below.)
å
3%.3/2å"90!33å-%4(/$åå
This method of arming allows you to dis-
able all sensors (e.g., shock sensor) while
keeping all other alarm triggers active
(e.g., door, trunk, hood, IG). Press Pager
Buttons I & II at the same time then release. The
doors will lock and hazard lights will flash once (if so installed). The siren
will chirp 2 times, the Pager will beep once and update as shown in Fig-1
but also with the icon, and the Status LED will light for 5 sec. (The si-
ren can’t be triggered while the LED is lit solid — See “Error Chirp” below.)
III
I II