Kiramek 1370S, Owner'S Manual, Page: 39 / 48

8
VISION 1370S INSTALLATION GUIDE
THE 14-PIN MAIN HARNESS
H1
!$$å
$)/$%3
425.+å37
$//2å37
$//2å37
7(4
H1
FIG­4: Connecting Door/Trunk Input
$/-%
,)'(4
425.+
,)'(4
"!44%29
H/'#%7'"+%#,00-'+#%.%@:A;<=%@RI%5.?2A%),$0,$%3)"%S.#/'*9%$/+%=+/'(-+O#%/.T ­
ard (turn signal) lights during security breaches (i.e., at times of Warning
Chirps and Full Siren Blast). See Fig­3 on the previous page.
H1-6 GRN wire: (+) Light Flash Output
This wire is one of four wires from the H1 main harness that forms the H2
sensor harness, as shown on page 5. The WHITE/RED wire is the “Full
Siren” trigger input wire from attached sensors (like the included shock
sensor). Any (–) ground signal on this wire will immediately trigger the full
siren blast. (See page 12 in the Owner’s Guide for more information.)
H1-7 WHT/RED wire: (–) Sensor “Full Siren” Input H2
H1-8 RED wire: (+) 12v System POWER
H/'#%7'"+%'#%$/+%5.'*%@:A%;<=%0)7+"%'*0,$%
to the 1370 system. Be sure to connect
this wire securely to a constant 12v source.
Connect this wire last so the siren doesn’t
go off. If you need to extend this 12v power
wire, use wire thicker than the RED wire. (The RED wire splits into two
wires to act as the power source of the H2 sensor harness. See page 5.)
H2
"!44%29
2%$
H1
NOTE:
If you connect the WHITE wire to the trunk, keep in mind that
the siren will go off when the trunk is opened while armed. Disarm the
system before opening the trunk.