Kiramek 1370S, Owner'S Manual, Page: 32 / 48

1
© 2007-2008 KIRAMEK, INC.
Precautions & Safety
OPERATION . Use of the 1370S outside its intended purpose as described in
this Installation Guide and the 1370S Owner’s Guide, could result in dam­
age to the vehicle or surrounding property, or cause serious injury or even
death. As the installer of this security system, it is your responsibility to
ensure that the vehicle owner is properly informed of all the details of your
installation which are pertinent to safety.
SAFETY POINTS TO ABIDE BY
:
1.
Never start the vehicle’s engine in enclosed spaces that lack adequate
ventilation. Extended exposure to carbon monoxide exhaust fumes
can result in death!
2.
Do not disconnect the vehicle’s battery, as it could cause serious prob­
lems with airbag systems, anti­theft radios or vehicle diagnostics. If
you absolutely must disconnect the vehicle’s battery, !"#$%&'#()**+($%
the main power wiring harness of the 1370S and then disconnect the
vehicle’s battery.
3.
Do not proceed with installing this system in vehicles that do not have
a 12­volt electrical system. This system will not function in 24­volt
trucks, and any damage resulting from such installation shall be the
sole responsibility of the installer.
4.
Do not install the 1370S control module or associated sensors in or
near water, or in a location where water could gather. The 1370 is
not waterproof and an electrical short could occur if water gets in­
side. Only the siren can safely be installed in the engine compart­
ment.
5.
Do not install the 1370S control module in an environment of intense
condensing humidity or steam, in an area with an unusally large
number of airborne particles, or any place where oil could build up
inside the control module case. All of these extreme environments
(),-&%-+.&%$)%.*%+-+($"'(.-%#/)"$%.*&%0)##'1-+%(.,#+%.%!"+2
6.
Avoid installing the 1370S and its associated sensors near sources
of intense RF transmissions which could possibly interfere with the
)0+".$')*%)3%$/+%#4#$+52%%63%4),%!*&%$/+%#4#$+5%'#%".*&)5-4%7)"8'*9%
and not working, consider relocating the antenna unit and sensors.