Kiramek 1370S, Owner'S Manual, Page: 21 / 48

6)3)/.å3å/7.%23å'5)$%
PROGRAM FEATURES EXPL AINED
When set to /&& (default), vehicle hazard lights will not illuminate after
disarming.
When set to
/.
, vehicle hazard lights will flash 3 times upon disarming
and then light solid for 30 seconds (or until the Ignition switch is turned
on) to illuminate the area surrounding the vehicle for greater security.
%XTERIORå)LLUMINATION
When you turn the Ignition on-and-off 20 times, you can then select one of
two features: (1) Transmitter Learning or (2) Manual Disarm Code. The
Transmitter Learning feature allows you to add new transmitters to your
system, as described on page 21. The Manual Disarm Code feature allows
you to program a unique code that will allow you to disarm the system even
without your pager remote. The factory default Manual Disarm Code is
“6,” but you should change this as soon as possible to your own unique code
for greater security.
To choose Manual Disarm Code , you must turn the Ignition on again
(for the 21st time), and then leave the Ignition on— follow steps given on
page 19 .
To choose Transmitter Learning , you must leave the Ignition turned
off (no need to turn it on for the 21st time)— follow steps given on page 21.
4RANSMITTERå,EARNINGåå-ANUALå$ISARMå#ODE
å #/-0!4)"),)49å ./4%
If your vehicle automatically activates the
dome light and/or other interior lights when doors are unlocked, you
must connect the 1370’s WHITE door input wire exactly as shown on pag-
es 7 & 8 in the Installation Guide—to the door switches themselves. Ex-
terior Illumination may not function properly if the 1370’s WHITE door
input is connected differently.