Kiramek 1370S, Owner'S Manual, Page: 24 / 48

Úåå+)2!-%+å).#
TRANSMIT TER LEARNING
You can program additional remotes to your 1370S system, or program
a remote to replace one that you have lost. You can program a total of 3
remotes.
0URPOSE
The following procedure will allow you to program transmitters:
Disarm 1. and then Turn IG on-and-off 20 times within 20 sec. of disarm-
ing. Hazard lights will then flash 20 times.
Wait 2. until hazard lights flash 20 times, then you have 10 seconds to
press and release Button-I on the first remote you wish to program. The
siren will then chirp once and the hazard lights will flash once to con -
firm your remote was learned. You will then have 10 seconds to press
and release Button-I on the next remote you wish to program. (You can
program up to 3 total.)
Turn 3. the Ignition on-and-off. The Status LED will flash the same num -
ber of times as the Manual Disarm Code. The siren will then chirp 3
times and the hazards will flash 3 times. Transmitter learning is now
complete!
0ROGRAMMINGå4RANSMITTERS
å)-0/24!.4
When programming more than one pager, only the first
pager programmed will receive answer-back communication from the ve-
hicle. Hence, there is little meaning to have more than one pager because
the second pager will only act as a 1-way transmitter. The primary rea-
son to purchase additional pagers is to have a backup in the event the
primary page is lost or damaged.
å./4%
Initiating Transmitter Learning deletes all transmitters from
memory for security. You must therefore relearn all your existing re-
motes each time you want to learn new remotes.