Kikusui TOS6200A, User Manual, Page: 79 / 154

TOS6200A/6210 REMOTE and SIGNAL I/O 5-3
5.2 SIGNAL I/O Connector
• To avoid electric shocks, always turn off the power supply of the related
equipment when connecting or disconnecting a cable from the SIGNAL I/O
connector.
The SIGNAL I/O connector is a D-SUB 25-pin connector located on the rear panel
used to control testing start and stop or to monitor the status of the tester.
Fig. 5-2 SIGNAL I/O Connector
Connector on the rear panel
Omron Corp. XM3B-2522 D-SUB 25-pin female connector, Screw M2.6 x 0.45
Complies connector (plug)
D-sub 25-pin male (with fix screw M2.6)
To avoid malfunctions caused by noise, use shielded-type D-sub 25-pin connectors
and a cable that is 2.5 m or less in length.
For information about how to obtain replacement parts, contact your Kikusui agent
or distributor.
For information about how to use these components, see the OMRON Corporation
catalogs.
Wire and tool that are necessary to make the connection
Wire
Single wire: 0.32 mm (AWG28) to 0.65 mm (AWG22) in
diameter
Twisted wire: 0.32 mm
2
(AWG22) to 0.08 mm
2
(AWG28)
Wire stripper A wire stripper that matches the wires listed above
WARNING