Kikusui TOS6200A, User Manual, Page: 124 / 154

6-40 GPIB and RS-232C TOS6200A/6210
6.5 List of Device Messages
About 1 and 2 at the right end of the List of Device Messages
1: Device messages available even during testing are indicated by a check (
✓
);
those not available are indicated by a cross (
✗
).
2: Device messages available even in the protection status are indicated by a check
(
✓
); those not available are indicated by a cross (
✗
).
Header
Data
Function and response data 1 2
Set value
Reso-
lution
Unit
1 *CLS Clears the status byte register, event status register,
device status register, protection register, fail register,
invalid setting register, and error register.
✓ ✓
2 *ESR? Returns the value of the event status register, then
clears it.
✓ ✓
3 *IDN? Returns the tester model name and ROM version.
✓ ✓
4 *RST Initializes the tester (to factory-shipped settings. Note
that interface settings are not initialized.)
✓ ✓
5 *SRE 0 to 255 Setting for the service request enable register
✗ ✗
6 *SRE? Returns the value of the service request enable register.
✓ ✓
7 *STB? Returns the value of the status byte register.
✓ ✓
8 BUZZERVOL
(BVOL) 1 to 10 1 Setting for the buzzer volume
✗ ✗
9 BUZZERVOL?
(BVOL?) Returns the value set for the buzzer volume.
✓ ✓
10 CLR Clears the input buffer and has it wait for a device mes-
sage. Equivalent to DCL and SDC.
✓ ✓
11 COMMENT(COM) 20H to 7EH 1st comment (memo) line ASCII codes """, "'",
",", and "@" cannot
be used in comments;
20 characters maxi-
mum.
✗ ✗
20H to 7EH 2nd comment (memo) line
20H to 7EH 3rd comment (memo) line
12
COMMENT?(COM?) Returns the comment (memo) contents.
✓ ✓
13 CONTACTCHECK
(CCH) 0|1|OFF|ON Setting for contact check.
(Test starts when a load is connected.)
✗ ✗
14 CONTACTCHECK?
(CCH?) Returns the ON/OFF status for the contact check.
✓ ✓
15 CONTRAST(CON) 0 to 10 1 Setting for contrast.
✗ ✗
16
CONTRAST?(CON) Returns the value set for contrast.
✓ ✓
17 CURRENT(CUR) 3.0 to 30.0 0.1 A Setting for test current
✓ ✗
18
CURRENT?(CUR?) Returns the value set for test current.
✓ ✓
19 DOUBLEACTION
(DAC) 0|1|OFF|ON Setting for start double action.
✗ ✗
20 DOUBLEACTION?
(DAC?) Returns the ON/OFF status for start double action.
✓ ✓
21 DSE 0 to 255 Setting for device status enable register.
✗ ✗
22
DSE? Returns the value of the device status enable register.
✓ ✓
23 DSR? Returns the value of the device status register.
✓ ✓
24
ERR? Returns the value of the error register.
✓ ✓
25 FAIL? Returns the value of the fail register
✓ ✓