Kikusui KHA1000, Operation Manual, Page: 42 / 274

2-12
KHA1000
Fig.2-7 Voltage input sensing, and wires used
Use wires UL1015 and AWG18 with a conductor exposure margin of 10 mm (indicated on the rear
panel). To secure the wires, tighten the screw part of the terminal with the accessory screwdriver.
2.4.4 Connecting the AC Power Supply or Line Impedance
Network (to SOURCE Terminals)
Connect the AC power supply or line impedance network to the SOURCE
terminals. Match the polarities (L, N, and G) of the terminals and the output
terminal polarities of the AC power supply or line impedance network to each other
(G is a protective grounding or grounding terminal).

Using the terminal covers
Fig.2-6
To prevent an electric shock, covers are attached to the LOAD and SOURCE
terminals.

Wire to be used and terminal treatment
Table 2-4
Select a wire according to the input current of the EUT. Attach a cramping terminal
to terminate the wire. Use a cramping terminal that has a screw mounting part with a
hole diameter of 6 mm and fits the wire.
INPUT
OUTPUT
L N G
EUT
AC power supply AC power supply
G N L G N L
G N L
Voltage sensing terminal
Enlarged view of plug
V
±
N
L
V
±
N
L
Wiring at time
of shipment
Terminal screw part
See
See