Kikusui KHA1000, Operation Manual, Page: 192 / 274

7-10
KHA1000
1.
Press the F1 key and set the current trigger level (A).
The current trigger level (A) that has been set is displayed in the selected menu on the
upper right of the display.
2.
Press the F4 key and set the voltage range.
Set the voltage range according to the input voltage. The current range is fixed to 20 A.
3.
Press the F3 key (Reset TRG).
The menu changes to Abort (Wait for TRG). To cancel triggers, follow the procedure
for “Canceling triggers” below.
4.
Turn on the power of the EUT.
When the current value exceeds the trigger level, the voltage/current waveforms are
updated. Once a trigger is generated, the display of the F3 key changes to Reset TRG.
5.
Press the F2 key (View Setting).
The relevant sub-menu appears.
6.
Press sub-menu F4 (Cursor).
While moving the cursor with the large knob, read the current values. You can also use
the small knob to move the cursor.

Canceling triggers
1.
Confirm that the F3 key menu is Abort (Wait for TRG).
2.
Press the F3 key.
Pressing the F3 key cancels Reset Trigger and inhibits triggers. The display keeps
displaying the current waveform. The F3 key menu changes to Reset TRG. To enable
triggers again, do as instructed in Step 3.

View Setting  Sub Menu
F1 Horizontal Scale
×10 ×5 ×2 ×1
×1/2 ×1/5
Set the view magnification. The view can be
enlarged or reduced. The same magnification
produces one-cycle of the waveform. The
setting changes after a trigger is generated. The
setting cannot be changed while the waveform
is being held.
F2
Vertical Scale
(Current)
×10 ×5 ×2 ×1
×1/2 ×1/4
Set the view magnification. The view can be
enlarged or reduced.
F3
Vertical Scale
(Voltage)
×10 ×5 ×2 ×1
×1/2 ×1/4
Set the view magnification. The view can be
enlarged or reduced.
F4 Cursor
Move the cursor within the display by turning the
small or large knob. The current or voltage value
at the cursor position is displayed.