Kikusui KHA1000, Operation Manual, Page: 197 / 274

KHA1000
8-5
8
R
em
o
te
C
o
n
tr
o
l
GPIB functions
Table 8-1 GPIB functions
IEEE 488.1 get, dcl, sdc, llo, and gtl commands
Service Request
Service Request and Serial Polling functions are installed.
8.4.2 RS232C Interface
RS232C connection
The RS232C port on the KHA1000 is a standard D-sub 9-pin male connector.
Check that the POWER switches of the KHA1000 and computer are off, and
connect the KHA1000 to the computer using a standard cross cable (null modem
cable).
Use a D-sub 9-pin female-to-female AT type for the cross cable. Fig.8-1 shows the
connector pin arrangement.
The KHA1000 does not use hardware handshaking (as shown in the cross cable
example 2).
Function Subset Content
Source handshake SH1 All functions supported
Acceptor handshake AH1 All functions supported
Talker T6 Function supported
Listener L4 Function supported
Service request SR1 All functions supported
Remote/local RL1 All functions supported
Parallel poll PP0 Function unsupported
Device clear DC1 All functions supported
Device trigger DT1 All functions supported
Controller C0 Function unsupported
Electrical interface E1 Open collector driver
Command Function
get Group Execute Trigger
Functions as a software trigger for starting the
measurement. (Equivalent to the *TRG command)
dcl/sdc
Device Clear/
Selected Dvice Clear
Aborts measurement and clears the command buffer.
llo Local Lockout Locks out the local key of this product.
gtl Go to Local
Restores the local operation mode of the front panel of
this product.