Kikusui KHA1000, Operation Manual, Page: 210 / 274

8-18
KHA1000
*SRE
Sets the service request enable register.
The service request enable register can be used to specify which summary message
in the status byte register should be used for a service request.
Send *SRE 0 to clear the service request enable register. The cleared service register
cannot be used to generate a service request based on status information.
Command
*SRE <NR1>
*SRE?
Parameter
Value: 0 to 255. An SCPI error (-222, “Data out of range”)
occurs if outside the range.
Example:
Sending *SRE8 sets bit 3 of the service request enable register. Every
time the summary bit (bit 3) of the QUEStionable status register in the
status byte is set, this bit generates a service request message.
Response
Returns the value of the service request enable register in the <NR1> format in
response to *SRE?.
*STB
Page 8-51
Queries the content of the status byte register and MSS (master summary status)
message.
The response is the same as serial polling except that an MSS message appears at bit
6 instead of an RQS message.
Command
*STB?
Response
Returns the values of the status byte register and MSS message (bit 6) in the <NR1>
format in response to *STB?.
*TRG
See Section 6.1.4.2.5
in IEEE 488.2-1992.
Trigger command.
This command is the same as the Group Execute Trigger command defined in IEEE
488.1.
Command
*TRG
See
See