Keysight Technologies InfiniVision 6000L Series, Service Manual

Page: 71 / 100

71
Keysight InfiniVision 6000L Series Oscilloscopes
Service Guide
5 Replacing 6000L
Assemblies
To remove the bottom cover / 73
To remove the front panel assembly / 74
To remove the system board / 76
To remove the power supply / 79
To remove the fan / 81
To remove the AC power input assembly / 83
To remove the power shaft / 85
This chapter describes how to remove assemblies from the Keysight 6000L Series
Oscilloscopes. After you have removed an assembly, to install the replacement
assembly, follow the instructions in reverse order.
The parts shown in the following figures are representative and may look different
than what you have in your oscilloscope.
Tools Used for Disassembly
Use these tools to remove and replace the oscilloscope assemblies:
• T10 TORX drivers
• 5/8-inch and 9/32-inch socket drivers
See how the Oscilloscope Parts Fit Together
An exploded view of the oscilloscope is included in the Chapter 6 , “Replaceable
Parts,” starting on page 87. It shows the individual part numbers used in the
assemblies, and shows you how all of the assemblies fit together.