Keysight Technologies InfiniVision 6000L Series, Service Manual

Page: 49 / 100

49
Keysight InfiniVision 6000L Series Oscilloscopes
Service Guide
3 Calibrating and Adjusting
This chapter explains how to adjust the oscilloscope for optimum operating
performance. You should perform self-calibration according to the following
recommendations:
• Every 12 months or after 2000 hours of operation
• If the ambient temperature is >10 °C from the calibration temperature
• If you want to maximize the measurement accuracy
The amount of use, environmental conditions, and experience with other
instruments help determine if you need shorter adjustment intervals.
Let the Equipment Warm Up Before Adjusting
Before you start the adjustments, let the oscilloscope and test equipment warm
up for at least 30 minutes.
Read All Cautions and Warnings
Read the following cautions and warning before making adjustments or
performing self-calibration.
WARNING
HAZARDOUS VOLTAGES!
Read the safety notice at the front of this book before proceeding.
Maintenance is performed with power supplied to the oscilloscope and with the protective covers
removed. Only trained service personnel who are aware of the hazards involved should perform the
maintenance. Whenever possible, perform the procedures with the power cord removed from the
oscilloscope.
CAUTION
REMOVE POWER TO AVOID DAMAGE!
Do not disconnect any cables or remove any assemblies with power applied to the oscilloscope.
Otherwise, damage to the oscilloscope can occur.