KEPCO BOP-ME 1KW, Operator'S Manual

Page: 112 / 234

3-36
BOP HIPWR 091719
FIGURE 3-13. NEW WAVEFORM MENU
2. Assign a name to the waveform: highlight Name, press
!
to modify, change the name
using the
Y
or
U
keys or ADJUST or the multiple presses of the numeric keys (see PAR.
3.2.4.1 for details). Press
$
to save or
%
to abort the change and exit.
3. Refer to Table 3-13 and enter the desired settings for Mode of Operation, Positive and Neg-
ative Protection and Count. These settings apply to all waveform segments. (Note that the
setting for mode cannot be changed once it has been saved; to change the mode, create a
new waveform.) For each parameter listed in Table 3-13 use
Y
or
U
or ADJUST to high-
light the parameter, then press
!
to edit, change the parameter, then press
$
to save or
%
to abort and exit.
4. Refer to Table 3-12 and enter the parameters for the first segment: Type, Frequency, Ampli-
tude (p-p) and Offset. For each parameter use
Y
or
U
or the encoder to highlight the
parameter, then press
!
to edit, change the parameter, then press
$
to save or
%
to
abort and exit.
5. When segment is complete, press
$
to save for power up. Continue to add segments as
desired by pressing
@
.
NOTE: When the first segment is added, start/stop angle is not accessible, however this can
be modified once the segment has been added.
6. When adding a new segment, the parameters of the highlighted segment are copied. It is
not possible to move or copy a segment to another location. Refer to Table 3-12, Note 2 for
details about initial vs. repeating segments. Refer to PAR. 3.3.10.9 for a detailed example of
how to add segments to build a complex waveform.
VOLTAGE
SOURCE
New Waveform Menu
Waveform Name:
Mode of Operation:
Number of Cycles:
Posititve Protect:
Negative Protect:
First Segment
Type:
Frequency (Hz):
PtoP Amplitude
Offset:
VOLTAGE CURRENT
0.0000 0.0000
Voltage
000
38.400
126.300
Sine
1.0000
200.0000
0.0000