kENDALL KANGAROO ePump, Operation And Service Manual

Page: 16 / 42

16
KANGAROO R R
e
Pump
™
English English
Continuous Mode (Adjust Feed)
Continuous Mode Feeding
For CONTINUOUS feeding mode, the ADJUST FEED option is available in the opening menus (Figure 7A for Feed-
Only sets or Figure 7B for Feed & Flush sets). Select this option to program the feeding parameters from the ADJUST
FEED screen, Figure 10A.
Press
4
FEED RATE
in Figure 10A to define the rate of delivery. Press the
4
buttons in Figure 10B to program the rate
from 1 to 400 in increments of 1 ml/hr. Press
4
ENTER (top button) to exit the menu.
Press
4
FEED VTBD in Figure 10A to define the Volume To Be Delivered. Press the
4
buttons in Figure 10C to
program the volume from 1 to 3000 ml in increments of 1 ml. Press
4
ENTER (top button) to exit the menu. If the
FEED VTBD
is set to zero, the pump will run until the supply is exhausted.
NOTE:
When a
FEED VTBD
is set, the remaining volume to be delivered (remaining VTBD) will be displayed next to
the v icon on the lower right-hand portion of the screen (Figure 10A). If the
FEED VTBD
is reprogrammed during
a feeding, from HOLDING mode, the pump will restart the feeding and deliver the entire volume of the new VTBD HOLDING HOLDING
setting.
Figure 9A. MORE OPTIONS menu. MORE OPTIONS MORE OPTIONS
Figure 9B. SELECT MODE menu for SELECT MODE SELECT MODE
continuous or intermittent mode
selection.
Selecting Continuous or Intermittent Feed Mode
The KANGAROO ePump enteral feeding pump can be programmed to feed continuously or intermittently.
The continuous feeding mode will deliver the enteral nutrition at a steady rate, either until the programmed volume has
been delivered or until the supply has been exhausted. The Intermittent feeding mode delivers boluses of enteral nutrition
at programmed time intervals. The bolus volume and feed rate are also programmed.
To select continuous feed mode or intermittent feed mode, press
4
MORE
on the opening menu, shown in Figures 5 or 7,
to access the MORE OPTIONS menu, Figure 9A. MORE OPTIONS MORE OPTIONS
The MORE option is available either before a Pump Set has been loaded (Figure 5) or after the Pump Set is loaded (Figure
7). See subsection “More Options” for information on the other options in the MORE OPTIONS menu. MORE OPTIONS MORE OPTIONS
Select
4
CONTINUOUS/INTERMITTENT
under the MORE OPTIONS menu, Figure 9A. Then press
4
CONTINUOUS MODE or
4
INTERMITTENT MODE from the SELECT MODE menu, Figure 9B. Press SELECT MODE SELECT MODE
4
DONE to
exit.
© 2005 Tyco Healthcare Group LP