KEN STONE XN10-8, Operation Manual

Page: 146 / 174

Troubleshooting
No Battery Power
No Battery Power
The following symptoms indicate no battery
power.
●
No rotation of starter motor or start failure
of engine.
●
Low volume of horn.
Remedy procedure
Start the engine by the booster battery on other
machine (booster machine) and jumper cable.
Warning
●
To start the engine by jumper cable,
ensure to connect the cable by correct
procedure. The improper use of jumper
cable will result in battery explosion or
unexpected machine motions.
• The booster machine and the machine
with depleted battery are prohibited for
mutual contact.
• The positive (+) and negative (-) clamps
of the jumper cable are prohibited for
mutual contact.
• During connection, firstly connect the
jumper cable to positive (+) terminal.
During disconnection, firstly disconnect
the cable from negative (-) terminal.
• Connect the last clamp of jumper cable
to a point as far as possible from the
battery.
cable to start engine.
Important: The jumper cable and clamps in use
shall be suitable to the battery capacity. Do not
use any damaged or corroded jumper cable or
clamp.
Important:
Ensure the same capacity for the
battery on the rescue machine and the battery
on malfunctioned machine.
Important:
Ensure to connect the cable clamps
securely.
Connection of Jumper Cable
Important:
Place the starter keys of both
rescue machine and malfunctioned machine to
OFF.
1. Connect a clamp of jumper cable (R) to
the positive (+) pole of malfunctioned
machine.
2. Connect the other jumper cable clamp (R)
to the booster (+).
3. Connect the jumper cable clamp (B) to the
charger (-).
●
Always wear goggles while using jumper
4. Connect the other clamp of jumper cable
6-3
To engine block