KEN STONE XN10-8, Operation Manual

Page: 138 / 174

Maintenance
As necessary
1. Lower the bucket steadily onto the ground as
shown in above diagram.
Note:
While disassembling the tooth pin, adjust
the bucket position in such manner that the
bucket barely comes into contact with the
ground. If the bucket is steadily on the ground,
the resistance will be really high so that it’s
difficult to disassemble the tooth pin.
2. Place the safety lock handle to locking
position and stop the engine.
3. Unfasten the fastening nut (1) and remove it.
4. Use a hammer to knock the tooth pin (2) off
the bucket.
5. Remove the bucket.
Installation
1. Align the pin hole (A) on the bucket with
the pin hole on the stick
①
, install the
tooth pin and the fastening nut.
2. 2. Operate the cylinder, align the pin hole
(B) on the bucket with the pin hole on the
connecting rod
②
, and install the tooth
pin and the fastening nut.
5-40
Disassembling
②
Ⓑ
Lubrication of Joysticks and Pedals
Warning
Adjust the machine to stop status, stop the
engine, and withdraw and properly preserve
the starter key. Otherwise, the machine will
probably move suddenly to cause serious
injuries or deaths.
In event of inflexible operation of any joystick
or pedal, please add oil for lubrication.