Operators Manual
Section 4-9
The four digit number displayed in the center is the
total time for the total of all lanes for the
cleaning/conditioning run in seconds (all lanes completed
and added together). When all the lanes for the programmed
run are finished, it converts this to minutes and seconds.
NOTE:
If the pump needs to be primed or a first lane test-
cleaning is needed, these functions must be chosen at this
time. Once the Start Button on the Handle is depressed the
ability to use these functions is turned off. Refer to the
RUN PREP SECTION of the manual.
At this time WITH THE MACHINE ON THE APPROACH, depress
the start button on the handle once. This will lower the
cushion roller/cleaning cloth and the squeegee assembly.
The vacuum motor along with the lane blower motor will come
on (if the program being used calls for the lanes to be
cleaned).
Push the machine into the first lane. Depress the
start button on the handle again and it will begin operating
on the lane.
When the machine finishes the first lane the screen
will change to:
0151 #02 IS NEXT
0000 0000 01
If the operator stops cleaning/conditioning the lanes
prior to finishing the last lane programmed, this screen
will display the next lane to be cleaned/conditioned.
This eliminates the chances of a lane being cleaned or
conditioned twice or not at all, but only if you enter the
proper starting and ending lanes.
When the last lane is completed the screen will
display:
00 LANES DONE IN
0000 MIN 00 SEC
