Operators Manual
Section 7-9
010 Duster Up Switch:
These two microswitches are
located on the top side of the Cushion Roller Pivot
Arms. When the cloth is wound up, a signal is sent
to the PC by one or both of these switches. These
switches are wired Normally Open. (LED #10)
(See drawing for Input 005.)
011 Pump Tachometer Sensor:
This pass-thru sensor is
located on the Oil Pump Motor Assembly, which is
mounted on the underside of the machine. The sensor
counts each revolution of the pump. (LED #11)
012 Left Proximity Sensor:
This sensor is found on the
left side of the Conditioning Compartment (1-1/8”
from the left side wall). The proximity sensor
senses metal, which is in the form of a flat head
screw located on the backside of the oil head block.
This sensor along with the right sensor have
multiple purposes. The main purpose is to reverse
the head drive motor. The proximity sensor also
acts as a guide for the position sensor by
indicating the lane edge when the oil head is
traveling from left to right. LED #12 will light up
on the input module.
013 Right Proximity Sensor:
This sensor is found on
the right side of the electrical wall in the
Conditioning Compartment (1-1/8” from the right side
wall). The proximity sensor senses metal, which is
in the form of a flat head screw located on the
backside of the oil head block. This sensor along
with the left sensor have multiple purposes. The
main purpose is to reverse the head drive motor.
The proximity sensor also acts as a guide for the
position sensor by indicating the lane edge when the
oil head is traveling from right to left. LED #13
will light up on the input module.
