Keba KeTop T100, User Manual, Page: 87 / 163

b) deactivate Allow serial cable or ...
→
<OK>
c) activate Allow serial cable or ...
→
<OK>
4) Start the ActiveSync-Software on the KeTop: Start
▶
Programs
▶
Com-
munication
▶
Active Sync
5) At the PC: Connect KeTop as a "Guest' (Set Up a Partnership
→
No ).
Now the data connection between the KeTop and the PC is established. In
case of communication problems, check the following conditions:
●
Max. time delay between step 3c) and step 4. = 30s.
●
For further attempts repeat steps 3. to 5.
●
The ActiveSync software must be started manually. (Plugging in the con-
nection cable does not start ActiveSync!)
The factory-set baudrate for the remote connection is 115 kBaud. In case of
communication problems the baudrate can be reduced. The baudrate can be
changed as follows:
1) Start
▶
Programs
▶
Communication
▶
Remote Networking
2) select "com1_115k"
3) File
▶
Properties
4) SP1 on COM1:
▶
Configure
▶
Port Setttings
5) Close all Windows with <OK>
7.10.2 Data connection via USB client
The data connection from the KeTop to the PC is established as follows:
1) Remove the cover of the cable entrance area on the KeTop.
2) Start the ActiveSync software on the PC
a) delete existing partnerships ( File
▶
Delete Partnership... )
b) activate USB connection ( Allow USB connections
→
<OK>)
3) Connect USB cable (Mini-B) to KeTop and PC. When the KeTop was
recognized as USB device, the connection will be established automati-
cally.
4) At the PC: Connect KeTop as a "Guest' (Set Up a Partnership
→
No ).
The ActiveSync software at KeTop starts automatically when using the USB
connection.
Software
© KEBA 2009
User's Manual V1.50 87