2) Insert the back-up battery into the connection slot as shown in the figure.
The screw heads serve to locate the back-up battery holder.
3) Position the connecting lead of the back-up battery so that it cannot be
pinched when the connection slot cover is fitted again.
4) Fit the connection slot cover, paying attention that no cables are pinched.
The back-up battery is now installed in the KeTop.
10.8.3
Run-up behaviour
The back-up battery is only active if it is already installed before the start of the
KeTop. During the boot procedure, the back-up battery is detected and indi-
cated by a status symbol in the taskbar under Windows CE.
Fig.10-28:
Status symbol for the back-up battery in the taskbar of the display
1
... Status symbol for back-up battery
Information
The back-up battery will not be recognised by the device if it is connected
while the KeTop is running.
The status symbol in the taskbar of the display can indicate the following sta-
tuses for the back-up battery:
Status symbol
Condition
Battery completely charged / being charged
Battery almost completely charged / being charged
Battery more than half discharged / being charged
Critical battery status (no further back-up possible) / being charged
Very critical battery status (no further back-up possible) / being
charged
Battery was removed during operation (this symbol appears only
if the back-up battery had not previously been initialised).
Accessories
© KEBA 2009
User's Manual V1.50
123
Summary of Contents for KeTop T100
Page 1: ...KEMRO KeTop T50VGA User s Manual V1 50 Translation of the original instructions ...
Page 4: ......
Page 10: ......