Instructions for use ESTETICA E70 Vision / E80 Vision
4 Operation | 4.14 Using the KL 703 LED in ENDO mode (optional accessory)
If the set speed differs from the recommended value of a file, a greyed-out
factory symbol is shown.
Use the "Save" key for saving in the profiles. You can save after setting each
parameter individually or after setting all parameters.
Setting the torque
The torque is limited to the set value.
Transmission ratio 1:1 / 3:1 / 8:1
The torque can be set in 0.1 Ncm steps in the range from 0.2 Ncm to 6.0 Ncm.
Note
The ENDO warning signals are emitted once a certain percentage of the set
torque value is reached.
75% slow signal tone
90% fast signal tone
100% continuous tone
▶
Tap Current torque (value in Ncm).
ð
Font colour switches to blue.
▶
Use slider to set the torque.
ð
The torque is shown on the display and is effective immediately.
If the set torque differs from the recommended value of a file, a greyed-out
factory symbol is shown.
Use the "Save" key for saving in profiles 1 to 8. You can save after setting each
parameter individually or after setting all parameters.
Set torque mode
Three different torque modes are available:
▪ Autoreverse
▪ Torque Control only
▪ Autorev / Forward
▶
Unfold the "Torque mode" list und select the torque mode as desired.
ð
Torque mode is shown on the display and is effective immediately.
Use the "Save" key for saving in profiles 1 to 8. You can save after setting each
parameter individually or after setting all parameters.
Set Autoreverse torque mode
▶
Press the foot pedal.
ð
The motor starts by rotating clockwise (if not selected otherwise).
121 / 178
Summary of Contents for ESTETICA E70 Vision
Page 1: ...Instructions for use ESTETICA E70 Vision E80 Vision...
Page 177: ......
Page 178: ...1 012 5446 Fk 20191030 9 en...