Juniper PTX5000, Hardware Manual

Page: 457 / 721

6. Attach the negative (–) DC source power cable lug to the –48V (input) terminal, located on the
right.
Use a 7/16-in. (11-mm) nut driver to tighten the nut.
CAUTION: You must use an appropriate torque-controlled tool to tighten the nuts.
Applying excessive torque damages the terminal studs and power supply. The
maximum torque that may be applied to this nut is 99 lb-in. (11 Nm).
CAUTION: You must ensure that power connections maintain the proper polarity.
The power source cables might be labeled (+) and (–) to indicate their polarity.
There is no standard color coding for DC power cables. The color coding used by
the external DC power source at your site determines the color coding for the leads
on the power cables that attach to the terminal studs on each power supply.
CAUTION: All inputs on the DC PDU in slot PDU0 must be powered by dedicated
power feeds derived from feed A, and all inputs on the DC PDU in slot PDU1 must
439