4
■
Installing the under cover
1) The under cover should rest on the four corners
of the machne table groove.
2) Fx two rubber seats
1
on sde
A
(operator’s
sde) usng nals
2
as llustrated above. Fx two
cushon seats
3
on sde
B
(hnged sde) usng a
rubber-based adhesve. Then place under cover
4
on the fixed seats.
3) Remove ar vent cap
5
attached to the machne
bed. (Be sure to attach cap
5
when transportng
the machne head n the state that the machne
head s removed from the machne table.)
If the sewing machine is operated with-
out removing air vent cap
5
, oil leakage
from gear box portion
7
may occur.
4) Ft hnge
1
nto the openng n the machne bed,
and fit the machine head to table rubber hinge
8
before placng the machne head on cushons
3
on the four corners.
5) Attach head support rod
6
to the machne table.
(However, ths step s not necessary for the ma-
chne wth AK
9
devce.)
23.5 mm
19.5 mm
1
4
A
B
4. INStALLAtIoN
4-1. Installation of the sewing machine head
WArNING :
• Perform the installation of the sewing machine by the technical personnel who have been trained.
• To prevent personal injury, ask our dealer or the electrician for electric wiring.
• Be sure to perform the work with two persons or more when transporting the sewing machine and use a
lorry when moving it.
• To prevent personal injury caused by abrupt start of the sewing machine, do not connect the power plug
until the set-up of the sewing machine is completed.
• Be sure to earth the ground wire to prevent personal injury caused by leak.
• Be sure to attach safety protection cover, finger guard, etc.
3
2
5
7
1
3
1
3
6
1
4
3
9
8
