JR ProPo C.O.L.T., Operation Manual

Page: 62 / 82

61
ᴾ
▋ Caution Note
For safety reasons, engine-powered and electric powered aircraft must have their motive power channels set to
the slowest speed.
If the Reverse Switches or Stick Mode are changed after setting the Fail Safe, the motive power failsafe may
be set, in error, to the Full Throttle position. In order to avoid making this dangerous mistake, be certain to
remember to implement the Fail Safe settings after completing the aircraft set-up.
Before flying, be certain to confirm the failsafe settings by switching off the transmitter power, and observing
that the servos move to the positions intended.
ᴾ ▋ Fail safe【FAIL SAFE】
▋ Function Explanation
If the receiver does not receive a valid RF signal from the transmitter, this function moves the
servos to predefined positions, to avoid the scenario of the aircraft crashing at, for example, full
throttle. Be sure to set the Fail Safe before flying each aircraft.
▋ Setting Method
This function allows selections to be made for each channel in case of loss of RF signal. “HOLD”,
maintains the servo positions as they were immediately before the radio signal was lost. This is
the default setting. It is also possible to select “FAIL SAFE”. In order to set the “FAIL SAFE”
positions (the servos move to predefined positions in the event of loss of radio signal), change the
switch for each of the channels on the screen to “FAIL SAFE”. The memorizing of each of the Fail
Safe positions is carried out by operating the stick to the desired position and holding it there
while pressing the “MEMO” key to activate this function.
Helicopter
Airplane
Glider
System List