JR ProPo C.O.L.T., Operation Manual

Page: 15 / 82

14
ᴾ
▋ Names and Functions of the Input Dial
This transmitter employs a jog-dial. When programming the transmitter, all operations can be performed very
intuitively using this dial. The dial functions by rotating it left or right, and pressing it.
▋ Jog Dial
“click” sound is heard confirming a valid input.
“click” sound may also be heard without any change to the numerical numbers on the
display. This is because numerical numbers below the decimal point are not displayed, even
thought the set value is changed internally.
By pressing down the dial for three (3) seconds, any set value can be changed to the default.
ᴾ
▋ TRIM 【Spoiler Trim, Rudder Trim, Aileron Trim,
Elevator Trim】
This function adjusts the response of the trim leavers, which are used to adjust the flight control surface by
changing their position. This transmitter uses Advanced Digital Trim (known as ADT) for all the trimming
channels. The ADT system is described below.
Trim indication display and audio sound.
The graphic bar on the display shows the amount of ADT which has been input by the trim levers. The Position
of the trim can also be recognized by the tone of the audio sound. The actual audio tone can be selectable in “TX
SETTING”. There are two tones available - High and Low.
These tones can also be muted.
Refer to the Page 54 "Transmitter Setting【TX SETTING】"
Auto Repeat Function and Center Click Function
The auto repeat function allows the trim lever to be continually pressed over to the side that you wish to adjust,
and the trim value is continuously increased or decreased using a fast-forward action. However, if the trim
position reaches neutral (center), it stops for a moment and produces a click sound to inform the user that the
trim is in the neutral position. If continuously pressed, the trim continues to move past the neutral position.
Trim Step Function
It is possible to adjust the trim step by using the TRIM SYSTEM under the System Mode.
Refer to the Page 53 "Trim System【TRIM SYSTEM】"
Memory function - Trim setting value
ADT is active in each of the model memories and the trim position is automatically memorized, even when
switching models. The memorized trim amount and trim step for the model are automatically set, and will not
be erased by changing models. In addition, each ADT can be given a different adjustment in each flight mode for
each model. When adjusting the ADT with the Flight Mode switch set to optional positions, only the trim amount
of the corresponding flight mode will be adjusted.
Under Glider mode, to adjust the horizontal movement of the Ailerons, (i.e. the Camber) use the Flaperon
trim. Again, all trim is memorized for each flight mode.
Functions Common to All Models
TIPS
TIPS
Dial
Display