6
ᴾ
▋
Inserting and Removing the Transmitter Battery
Battery connector
Battery box
Battery cover
Preparation
1)
To open the battery cover, lift the tab on the rear of the transmitter.
2)
3)
※Due to characteristic of the paint, the battery cover and radio case may stick together slightly.
Simply wiggle the battery cover left and right to remove.
When removing the
connector, press the lever
to release the lock while
pulling out the connector.
1
2
CAUTION
(DC15V) charging jack
To charging jack
(only for Li-ion battery charging TX)
To AC outlet
Charging Indicater
LED
The stock LiFe battery (2F1400 #04153) connects with a single connector.
The optional Li-Ion battery (2L3200 #04158) connects using two connectors.
Fit the rechargeable battery into the battery box, and close the battery cover, taking care not to pinch the
lead wires. During charging, the transmitter LED will light in a green color. When charging is finished, the LED
will switch off. The standard charge time is approximately 3 hours.
ᴾ
▋
Charging the Transmitter Battery
Before charging the battery, be certain to read the precautions written on the battery label.
The transmitter operates exclusively with genuine JR batteries. Do not use the transmitter with other
rechargeable batteries or with dry cell batteries.
During charging, the transmitter should be switched off. When the transmitter ON, charging will not take place.
Note that if using a flight simulator with the control cable plugged into the trainer jack (and the power switch OFF
on the transmitter), it is possible to plug the charge cable into the transmitter and use the AC adaptor to supply
power. Since the built-in battery will not be used, this will allow enjoyment while conserving energy.
1)
Insert the AC adaptor into the AC electric power socket.
2)
Insert the plug of the AC adapter as far as it will go into the DC power jack of the transmitter. If the LED of the
transmitter does not illuminate, an error may have occurred. In this situation, detach the AC adapter plug, and
re-insert it. If the LED does not light even after the cable has been removed and inserted several times, please
contact your JR agent or distributor in your country.
3)
During charging, the LED of the transmitter will light Green. When charging is complete, the LED
will switch off. The standard charging time is approximately 3 hours.
4)
After charging has been completed, promptly detach all the connections. Do not leave the charger connected
to the transmitter.
※
Be certain to only use the genuine JR C.O.L.T. dedicated AC adapter (NEC-A1530). Charging cannot be carried out
using other AC adapters. Further, do not use this AC adapter for charging products other than the C.O.L.T..
Warning！ Abnormal
heat generation may cause explosion of the battery!
After charging is complete, detach all of the connections including the AC adaptor from the outlet.
Never leave the AC adaptor connected to the transmitter or plugged into the AC outlet. This is to avoid
possible fire risk after charging the battery.
WARNING
Do not use the AC adapter while the cord is still bundled
together, since there will be a risk of heat generation.
CAUTION
During charging : Green
15V30W AC adaptor(NEC-A1530)
※ The AC adaptor may accept all types of plug adaptors (travel adaptor) to convert it to your requirments.
But please make sure that it is fitted correctly.
BATTERY FAULT : Red
2L3200
If using the optional Li-Ion battery (2L3200),
be sure to plug in the both connectors.
（Sold separatory）
Summary of Contents for C.O.L.T.
Page 1: ...Classic Old Looking Transmitter...
Page 82: ...http www jrpropo co jp...
