JR ProPo C.O.L.T., Operation Manual

Page: 8 / 82

A
A
A
B
B
B
7
▋ Stick tension adjustment
and throttle travel adjustment plate
▋ Adjustment of the stick spring strength
① Remove the battery before carrying out any adjustments.
② Remove the screws from the six locations shown.
③ Adjust the springs to the desired spring tension.
By carefully adjusting each of the screws, you
can achieve a range of spring tensions.
④ Close the rear cover, and tighten the screws.
Take care of interlocking of the levers, etc.
If you prefer a ratchet on the throttle, replace
the spring plate as shown.
※ The drawing on the right shows the default
setting, giving a smooth throttle transition.
Never Touch the Printed Circuit Board or any
related parts inside the transmitter.
※ Touching the board may result in electric shock, uncontrolled microcomputer operation, or
damage to model data, and normal operation may become impossible.
Detail of this area.
Screw to secure spring
Screw for spring adjustment
Screw to secure spring
Screw for spring adjustment
Contact Surface
※Ratchet operation
※Smooth operation
Direction of the
Ratchet spring Direction of the
Ratchet spring
Direction of the
Ratchet spring Direction of the
Ratchet spring
Contact Surface
Preparation
Screws(Black)×6
※ STICK TYPE MODE 1
By adding the throttle stroke adjustment plate to the gimbal, the
throttle stroke is limited by approximately 5 degrees.
Be sure to install or remove the plate with reference to the
drawing.
When adding this "limiter plate" it is essential to recalibrate the
throttle stick range. Be sure to follow this procedure.
Note:
Refer to the Page 76 "Transmitter Setting【TX SETTING】" in the
system list for further details of calibration.
▋Throttle travel adjustment
For the Throttle
For the Aileron
For the Elevator
For the Rudder
※ STICK TYPE MODE 2
For the Throttle
For the Aileron
For the Elevator
For the Rudder
Throttle adjustment (mode 1 shown)