JR ProPo C.O.L.T., Operation Manual

Page: 25 / 82

24
ᴾ ▋ Throttle Curve【THRO CURVE】
▋ Function Explanation
▋ Setting Method
There are three initial curve points set at the low, center, and high positions. To add a point, set the stick to the desired position
and press “ADD” on the screen using the dial. In the situation where a point is to be deleted, this should be carried out by placing
the cursor on “DEL” and press the dial. To change vales at each point, rotate the dial to move to and select the point that you wish
to change (inverse display). Then press the dial to select and change the numerical value.
▋ For Helicopter
There are two (2) flight modes
(Normal & Stunt) available for
helicopter throttle curves. Set each
throttle curve as desired for the
particular flight condition.
Function List
Helicopter
Airplane
Adjusting point Display
This changes the point connections to a Curve.
Numerical Display of the Stick
input Position and output position
Current Flight Mode position
Each Adjusting point input
Position and output position
ADD / NON / DEL
Point addition and deletion
Copying Curve
Value of throttle stick position
Output value to the Servo
Direction of the point: Left/Right Direction of the point: Left/Right
Direction of the point: Up/down Direction of the point: Up/down
Stunt mode
Normal mode
This function adjusts throttle servo operation in response to throttle stick operation. The servo
position can be set independently for a maximum of 5 point positions. In addition, an EXPO
function is incorporated to allow smooth connection of each of the points. This function is
available in each Flight Mode for helicopters (maximum 2), and 1 mode for airplanes.