JR ProPo C.O.L.T., Operation Manual

Page: 64 / 82

63
ᴾ
▋ Device Select【DEVICE SELECT】
▋ Function Explanation
This screen is where various flight modes can be set, and where switch functions can be defined.
Further, channel output assignments can be made here.
▋ Setting Method
▋ For Airplane
Airplane
Glider
Selection of Output (OUT)
Device Select
(DEVICE)
Device Select (DEVICE)
Here input devices (switches, and levers) can be linked to a particular channel. Select the device as desired.
Selection of Output (OUT)
Here the Output configuration of each channel can be specified.
INH: No output.
ACT: Allow output - standard.
SYS: Use this channel for the Flap system.
GYRO: Use this channel for the Gyro Sensitivity.
※ By setting the flap channel to “SYS”(SYSTEM),
the menu “FLAP SYSTEM” under the function List is activated.
By setting the 5 or 6 channel to “GYRO”,
the menu “GYRO SENS” under the function List is activated.
System List
▋
For Glider
Device Select
(DEVICE)
Land Switch (LAND)
Launch Switch Reverse
(LAUNCH REV)
Launch Switch
(LAUNCH)
Launch Switch (LAUNCH)
By setting up a LAUNCH (Launch Switch) it is possible to set two additional flight Modes:
Cruise Mode (CRUISE)
Launch Mode (LAUNCH)
Launch Switch Reverse (LAUNCH REV)
It is possible to switch the Launch Switch position on the Flight Mode switch.
OFF : The Upper switch position (POS0) will be set as Cruise and the Bottom switch position (POS1) will be set as LAUNCH (Launch Mode).
ON : The Upper switch position (POS0) will be set as Launch and the Bottom switch position (POS1) will be set as Cruise (Cruise Mode).
Land Switch (LAND)
By setting up a LAND (Land Switch) it is possible to set the following two flight Modes:
Cruise Mode (CRUISE)
Launch Mode (LAUNCH)
Device Select (DEVICE)
Here input devices (switches, levers and trim switches) can be linked to a particular channel. Select the device as desired.
Selection of Output (OUT)
Here the Output configuration of each channel can be specified.
INH : No output.
MOT : Use this channel for Motor control.
※ When the Motor Channel is set, “MOTOR SYSTEM” on the function List becomes activated.
TIPS
Even though a channel's OUT (Output) can be set to “INH”, it is possible to use the channel with a “PROGRAM
MIX” (on the function List) as a Master channel. It is also possible to set this under “DEVICE SELECT”
Touch Select function: When selecting a switch, by operating the switch that you wish to use, the switch will be
automatically recognize and be set to that function. It is useful when you are not sure of the switch name.
It is possible to select from the following two (2) movement options when using a trim lever as an Input device:
2P: 2 position movement
/ MO: Momentary Movement
▋ Caution Note
Actually operate the servos and carefully confirm the settings before flying.
Selection of Output (OUT)